UNIX2DOS(1) User Commands UNIX2DOS(1)

NAME

unix2dos - convert text file from ISO format to DOS format

SYNOPSIS

unix2dos [-ascii] [-iso] [-7]
[-437 | -850 | -860 | -863 | -865] originalfile convertedfile

DESCRIPTION

The unix2dos utility converts ISO standard characters to the
corresponding characters in the DOS extended character set.


This command may be invoked from either DOS or SunOS. However, the
filenames must conform to the conventions of the environment in which
the command is invoked.


If the original file and the converted file are the same, unix2dos
will rewrite the original file after converting it.

OPTIONS

The following options are supported:

-ascii
Adds carriage returns and converts end of file characters
in SunOS format text files to conform to DOS requirements.


-iso
This is the default. Converts ISO standard characters to
the corresponding character in the DOS extended character
set.


-7
Converts 8 bit SunOS characters to 7 bit DOS characters.


On non-i386 systems, unix2dos will attempt to obtain the keyboard
type to determine which code page to use. Otherwise, the default is
US. The user may override the code page with one of the following
options:

-437
Use US code page


-850
Use multilingual code page


-860
Use Portuguese code page


-863
Use French Canadian code page


-865
Use Danish code page

OPERANDS

The following operands are required:

originalfile
The original file in ISO format that is being
converted to DOS format.


convertedfile
The new file in DOS format that has been converted
from the original ISO file format.

SEE ALSO

dos2unix(1), ls(1), attributes(7)

DIAGNOSTICS

File filename not found, or no read permission

The input file you specified does not exist, or you do not have
read permission. Check with the SunOS command, ls -l (see ls(1)).


Bad output filename filename, or no write permission

The output file you specified is either invalid, or you do not
have write permission for that file or the directory that
contains it. Check also that the drive or diskette is not write-
protected.


Error while writing to temporary file

An error occurred while converting your file, possibly because
there is not enough space on the current drive. Check the amount
of space on the current drive using the DIR command. Also be
certain that the default diskette or drive is write-enabled (not
write-protected). Notice that when this error occurs, the
original file remains intact.


Translated tmpfile name = filename.
Could not rename tmpfile to filename.

The program could not perform the final step in converting your
file. Your converted file is stored under the name indicated on
the second line of this message.


September 14, 2000 UNIX2DOS(1)